........................................From the other thread.....................................
https://www.jfkassassinationforum.com/index.php/topic,3832.16.htmlStop the above youtube at 0:54.
I'm not sure that the JFK Limo was partially traveling inside the Fast Lane vs being completely inside the Center Lane. Your video below shows the knockoff JFK Limo being entirely inside the Center Lane. Much like the SBT and the placement of Gov Connally's jump seat vs the position of JFK, you are doing likewise by moving the JFK Limo inside the Fast Lane vs SA Hickey's position inside the Queen Mary.
Yes, the problem of the AR15 is like the SBT. But, the SBT works (ie re line & angle), & the AR15 theory works (ie re line & angle).
U correctly mention that we dont know whether the jfklimo was completely inside the center lane. But this is not critical. If the jfklimo was half in the fast lane then this would only make a say 40 inch difference to the alignment of the limo center line where it meets Tague, ie the center line moves 40 inches to the left, ie a 40 inch offset, but is still parallel, ie the angle to Elm St duznt change in the 2 scenarios, ie if Queen Mary too was half in the fast lane.
Notice that in the above frame the jfklimo is say 20% in the fast lane. I forget where i got that frame. Its from one of the members here. But i painted the stars etc. It shows jfk sitting well right, but at Z312 jfk's head was lower & very near the center line of the limo (ie where the lowest star is drawn)(that star is supposed to show the inshoot)(the hollow star shows the position of the crack damage).
What duznt work is the theory that Oswald fired the headshot, ie from the sniper's nest. The angles are wrong (Donahue in Mortal Error).
And a Carcano FMJ duznt explode (Donahue in Mortal Error)(however soft point Carcano's were available)(& Oswald could have made his own Carcano hollow-point i suppose).
I cant remember whether the horizontal line & angle problem for the AR15 has been dealt with in much detail on this forum.
The vertical line & angle problem has been dealt with in this present thread & in a Bronson footage thread that i started a couple of years ago.
https://www.jfkassassinationforum.com/index.php/topic,2836.32.htmlDonahue dealt with the vertical line & angle problem for the AR15 in Mortal Error. Not so much the horizontal line & angle problem i think.
Daniel R Roffe wrote a book......... JFK Motorcade: The Accidental Shooting Death of President John F Kennedy.
This deals mainly with the horizontal & vertical line & angle problem i think.
I could not find a used copy for sale on the internet, but would cost about $200.
And i could not find any info or drawings from the book.
As detailed in this thread, some or all of the AR15 shots had to pass throo the gap between the upturned vizors on Queen Mary.
And one or two might have had to pass throo the gap between the upturned vizors in the jfklimo.
All of the shots had to pass over the windshield of Queen Mary.
And the 2nd last shot which dented the chrome trim above the mirror in the jfklimo had to pass under the divider/roll-bar of the jfklimo. In the above frame the divider/roll-bar has been left out (because the frame originally dealt with the SBT i suppose, it did not deal with the AR15).
And the remnant slug from the last shot, the head shot, had to veer 6 deg inside the head, & then crack the windshield.
6 deg is a big ask for a hollow point.
But it works, it has to work.
It was rotten luck, he was just doing his job.